ã€principle】
Agarose is selected and made from a pure agar as a raw material. Agar is chemically a complex composed of agarose and agarose. Agar gum is a polysaccharide containing sulfate and hydroxyl groups, which has ion exchange properties, which can adversely affect electrophoresis and gel filtration. Agarose is a linear polysaccharide composed of alternately arranged residues of D-galactose and 3,6-anhydro-L-galactose.
Agarose forms a gel mainly by hydrogen bonding. Due to the large water content of the gel during electrophoresis (98-99%), it is approximately free electrophoresis. Because the effect of the solid support is small, the electrophoresis speed is fast and the zone is neat. Moreover, since agarose does not contain a charged group, electroosmosis has little effect, and it is a good electrophoretic material, and the separation effect is good.
Lipids in serum are present in combination with serum apolipoproteins in the form of water-soluble lipoproteins. The types and amounts of apolipoproteins contained in various lipoproteins are different, and the size of various lipoprotein particles is also very different. Therefore, using agarose gel as a support, various lipoprotein particles can be separated in an electric field. Come.
Separation of serum proteins by agarose gel electrophoresis is simple. Serum lipoprotein is pre-stained with the lipid dye Sudan Black (or oil red, etc.). The pre-stained serum was then applied to the agarose gel plate loading tank, and after being energized, the lipoprotein was observed to move toward the positive electrode, and several zones were separated.
Normal human serum lipoprotein can appear in three zones, from the cathode to the anode, β-lipoprotein (the deepest), pre-β-lipoprotein (the shallowest) and α-lipoprotein (slightly deeper than the pre-β-lipoprotein) There should be no chylomicrons at the origin. Sometimes the pre-beta-lipoprotein is not shown.
Agarose forms a gel mainly by hydrogen bonding. Due to the large water content of the gel during electrophoresis (98-99%), it is approximately free electrophoresis. Because the effect of the solid support is small, the electrophoresis speed is fast and the zone is neat. Moreover, since agarose does not contain a charged group, electroosmosis has little effect, and it is a good electrophoretic material, and the separation effect is good.
Lipids in serum are present in combination with serum apolipoproteins in the form of water-soluble lipoproteins. The types and amounts of apolipoproteins contained in various lipoproteins are different, and the size of various lipoprotein particles is also very different. Therefore, using agarose gel as a support, various lipoprotein particles can be separated in an electric field. Come.
Separation of serum proteins by agarose gel electrophoresis is simple. Serum lipoprotein is pre-stained with the lipid dye Sudan Black (or oil red, etc.). The pre-stained serum was then applied to the agarose gel plate loading tank, and after being energized, the lipoprotein was observed to move toward the positive electrode, and several zones were separated.
Normal human serum lipoprotein can appear in three zones, from the cathode to the anode, β-lipoprotein (the deepest), pre-β-lipoprotein (the shallowest) and α-lipoprotein (slightly deeper than the pre-β-lipoprotein) There should be no chylomicrons at the origin. Sometimes the pre-beta-lipoprotein is not shown.
ã€operating】
1. Add 0.2 ml of Sudan black staining solution to 0.2 ml of pre-stained serum, mix and stain for 30 minutes in a 37 ° C water bath, and centrifuge (2000 rpm) for about 5 minutes. To remove the dye residue suspended in the serum.
2. Preparation of agarose gel plate The prepared 0.5% agarose gel was heated and thawed in a boiling water bath, and the gel solution was pipetted onto a glass slide with a pipette, about 3 ml. Allow to stand for half an hour after solidification (expanded when hot, or put in the refrigerator for a few minutes to accelerate coagulation).
3. Draw the cut filter paper in half, and cut the sample at a distance of 2 cm from the end of the gel. Insert the capillary into the pre-stained serum. After inhaling part of the serum, take a capillary tube so that one end of the sample is placed against the end of the sample mouth and stop for about 3 seconds.
4, electrophoresis, put the gel plate into the electrophoresis tank, make the sample end connected to the cathode side, use four layers of filter paper or gauze to make the "bridge", apply to the two ends of the rubber sheet, each lap the gel plate About 1 cm, the other end of the "bridge" is immersed in the barbital buffer in the electrophoresis tank. Turn on the power, first adjust the current to 3-4mA / gel plate, electrophoresis for 10-15 minutes; then adjust the current to 6-7mA / gel plate, electrophoresis for 30-40 minutes, you can observe the separation zone.
5. If you need to keep the electropherogram, you can soak the gel plate (with the slide) after electrophoresis in clean water for 2 hours, then put it in an oven (about 80 °C) to dry.
ã€Reagents】
1. Sultan black staining solution added Sudan Black B to absolute ethanol to saturation and shake to acetylate. Filter before use.
2. Barbiturate buffer Weighed 15.4g of barbital sodium, 2.76g of barbital and 0.29g of EDTA. After adding water, add distilled water to 1000ml (pH 8.6, ionic strength 0.075) as electrode buffer.
3. The gel buffer solution was taken from 1.212 g of tris(hydroxymethyl)aminomethane, 0.29 g of EDTA, and 5.85 g of NaCl. After dissolving in distilled water, it was diluted to 1000 ml, and the pH was 8.6.
4. Agarose gel Weighed 0.45 g of agarose in 50 ml of gel buffer and added 50 ml of water. Heat to boiling in a water bath and stop heating immediately after the agarose is completely dissolved.
ã€Precautions】
1. The electrophoresis sample should be fresh fasting serum.
2. When heating and melting agar, it is necessary to prevent excessive evaporation of water. The agarose gel is preferably used as needed to prevent the gel surface from drying and affecting the separation effect.
3. When preparing the gel plate, the agarose concentration is generally about 0.5%, the α-lipoprotein fraction is more than 1%, the β and pre-beta-lipoprotein fractions are not clear enough; the coagulation is less than 4.5%. Poor, the map is unclear.
4, the sample mouth should be the appropriate size, the edges are neat and smooth, otherwise it will affect the electropherogram.
5. If there is a shallow zone before α-lipoprotein, it can be listed as pre-alpha-lipoprotein.
[normal reference range]
--lipoprotein 20~30%
--lipoprotein 20~30%
Pre-β-lipoprotein 0~28%
Milk thistle particles (-)
Gaffer tape introduction
1. Material
Our gaffer tape is based on premium grade cloth fabric, combined with matt polyethylene, coated with synthetic rubber adhesive or natural rubber adhesive.
2. Features
Our Gaffer tape has following features:
a. Strong adhesion, we coated with high quality imported glue.
b. Heavy duty, it is made from strong material, thickness reaches 250micron, 270micron and 300micron.
c. Matt surface, non reflective.
d. No residue when removal.
e. Different colors for choosing. We have black, orange, pink, apple green, other colors also can be customized.
Gaffer Tape,Cloth Gaffer tape,Gaffers Tape,Gaff Tape,Black Gaffer tape,Gaffer duct tape
Kunshan Jieyudeng Intelligent Technology Co., Ltd. , https://www.jerrytape.com