The harvester receives the autumn cut from the summer and has a long parking time. If it does not pay attention to management, it will shorten its service life. The following points should be made:
Anti-day sun exposure
No matter what kind or model of harvester you are, regardless of the size of your body, you should have your own hangar. Some operators are afraid of trouble. They will only take simple shelters and shelter from wind and rain. The body will be damaged to varying degrees. Therefore, regardless of the type of harvester, you should try to cover the dedicated library.
Anti-dirt rust
After harvesting in each quarter, the dirt, swarf, gully, grains, and other debris inside and outside the harvester should be completely removed, and the inside and outside of the machine should be rinsed, dried, and stored in the computer room. At the same time, the lubricating parts shall be cleaned, lubricated or sealed with oil. The parts where the protective paint falls off shall be timely painted and rustproof.
Anti-deformation decay
Improper storage of various transmission belts may cause mildew or deformation. After use, these parts should be removed, wiped and dried, stored in a ventilated place, and protected from insect or rat bites. All metal drive chains are washed with diesel oil or kerosene and dried, then put into oil for 15 to 40 minutes or soak in oil overnight, and when the oil is not dripped, apply grease, and wrap it in kraft paper. In a dry and ventilated place.
Anti rubber aging
The rubber and plastic products on the harvester are susceptible to aging and deterioration due to the effect of sunlight and ultraviolet rays, and they have poor elasticity and are easily broken. Therefore, for the storage of rubber parts, it is best to apply hot paraffin oil on the surface of the rubber parts, and place them indoors where they are ventilated, dried, and exposed to direct sunlight.
Plastic deformation
Springs, belts, shanks, tires, etc., may be plastically deformed due to prolonged stress or improper placement. For this reason, some places need support, and wood can be used to lift the frame so that the tires are not under pressure. All the pressure springs are loosened, the belt is removed and stored separately, and the long shaft is removed to lay flat or hang vertically.
Loss of small items
Randomly used appliances, especially special tools and various spare parts, are best kept in registration, kept by special personnel, put back in place after use, and should not be placed after use.
The light will automatic adjustment according to person's remove.Can be opened and closed for lighting control , dimming functions of light independent control, also can be combined on a plurality of lamp groups with different lighting control, convenient arrangement and combination form to create a specific atmosphere.As your pleases set up lighting lamp; open light from dark to bright gradually, closed from bright to dark until closing gradually, is conducive to the protection of the eyes, but also can avoid the high transient current caused by the impact of the lamp, can effectively prolong the service life of the lamp.
DMX System,DMX Controller For Hotel,DMX Controller
Shenzhen Zhuohao Intelligent Electronic Development Co., Ltd. , https://www.szactop-smart.com