1. Preparation before start-up (1) New or long-term sealed gasoline engine, remove the cylinder oil at the time of unsealing, unscrew the spark plug, pull the crankshaft with the starter rope several times to drain the oil from the spark plug hole, dry the spark plug hole and the electrode Oil, and then check whether the spark plug flashes. When testing spark plug sparks, the spark plug thread should be affixed to the cylinder head and pull the starter wheel. It is forbidden to put the spark plug on the carburetor to test the fire so as to avoid burning the machine. (2) Check if the screws and nuts are firm and normal. (3) Turn the starter wheel by hand to check whether the compression force of the cylinder is normal and whether the moving parts are stuck. (4) Fuel oil is strictly blended in proportion. The volume ratio of gasoline to engine oil is 15:1 in the first 50 hours of the operation of the new gasoline engine and 20:1 thereafter. In addition, care should be taken to allow the oil to pass through the strainer of the tank to prevent impurities from entering the tank. (5) Turn on the oil switch and press the starter plus rich button on the float chamber to see if fuel flows from the air cleaner. If the oil has not been spilled before the enrichment button is pressed, the floater housing can be tapped with the handle to correct the connection between the needle valve and the float bracket and the needle valve and needle valve seat. If the oil is still spilling, bend the float bracket down to lower the height of the float chamber oil level. 2. Starting Steps and Precautions (1) Close the choke valve from 1/2 to 2/3 (the heat engine can be turned off) in order to enrich the air-fuel mixture. (2) The hand throttle is fully open or open 1/2. (3) Press the start plus thick button to make the carburetor spill (oil may not press) to increase the concentration of the mixture. (4) The left foot is placed on the lower rack and the starter rope is wound 2~3 times clockwise on the starter wheel. Hold the gasoline engine with your left hand, and quickly pull the starting rope with your right hand. When pulling the rope, you should pay attention to the fixed gasoline engine to prevent the machine from overturning. It is necessary to prevent the starting rope from winding around in the hand to prevent injury to the body when the crankshaft is reversed. (5) After the start of the gasoline engine, gradually open the large throttle, and properly put the hand throttle on the lowest speed position. After the gasoline engine is working normally for 3 to 5 minutes, accelerate the load operation. 3. Precautions during operation (1) Do not suddenly increase the throttle at high speed during operation. Pay attention to the body temperature, sound, and smoke at any time. If abnormal phenomena occur, check the machine immediately. (2) Run at low speed for 3 to 5 minutes before shutting down. At the end of each shift, turn off the throttle switch to allow the carburetor to burn off and shut down automatically. 4. Save (1) Put clean fuel tank and float chamber fuel. The overall inspection and maintenance of the whole machine. (2) Unscrew the spark plug, inject 20-25 drops of vehicle oil into the cylinder, and turn the crankshaft to evenly distribute the oil. Then place the piston at the top dead center and reinstall the spark plug. (3) Pack the whole machine well, place it in a ventilated and dry place, and if necessary, keep the magnetic motor dry separately.
Unique Beef Paste Chili sauce,Fresh Beef Paste Chili Combo,Selected Beef Chili Sauce,Delicious beef sauce with rice
Guizhou Guisanhong Food Co., Ltd , https://www.guisanhong.com